2.3.2. Inserting the Batteries in the Remote Control
The remote control is powered by two 1.5V AAA batteries.
To install or replace the batteries:
1. Press and then slide the cover to
open it.
2. Insert the batteries with the correct
polarity (+) and (–).
3. Replace the cover.
CAUTIONS:
Incorrect use of batteries may cause leakage or explosion. Be sure to follow the
instructions below:
•
Replacement of a battery with an incorrect type that can defeat a safeguard
•
Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of
a battery, that can result in an explosion
•
Leaving a battery in an extremely high temperature surrounding environment that
can result in an explosion or the leakage of flammable liquid or gas
•
A battery subjected to extremely low air pressure that may result in an explosion
or the leakage of flammable liquid or gas
•
Risk of fire or explosion if the battery is replaced by an incorrect type
NOTE:
Remove the batteries from the battery compartment when not using for an extended
period of time.
2.3.3. Handling the remote control
•
Do not drop or apply shock to the remote control.
•
Do not allow any liquid to get inside the remote control. If water has entered the
remote control, wipe the remote control with a dry cloth immediately.
•
Do not place the remote control near heat and steam sources.
•
Do not attempt to disassemble the remote control, unless you need to place
batteries in the remote control.
Parts and Functions
7