Huawei SmartLi 2.0 User Manual page 96

SmartLi 2.0
User Manual
Parameter
Battery
undervoltag
e protection
time (h)
Table 5-3 Alarm parameter description
Parameter
Battery
cabinet EPO
Copper bar
overtemper
ature
Fire
extinguisher
cylinder
pressure
abnormal
Battery
overcurrent
(discharge)
Issue 10 (2022-04-30)
Description
If batteries have not been charged for a
long time when they are running, set the
automatic battery switch-off time to
prevent batteries from being damaged
due to overdischarge. Set this parameter
based on the site requirements.
Description
Before setting this parameter to Enable,
ensure that the EPO cable is correctly
connected. After it is set to Enable, the
EPO switch can be triggered to perform
EPO.
● If this parameter is set to Enable, an
alarm is reported when the copper bar
is overheated.
● If this parameter is set to Disable, no
alarm is reported when the copper bar
is overheated.
● If this parameter is set to Enable, an
alarm is reported when the fire
extinguisher cylinder pressure is
abnormal.
● If this parameter is set to Disable, no
alarm is reported when the fire
extinguisher cylinder pressure is
abnormal.
● If this parameter is set to Enable, an
alarm is reported when battery
overcurrent occurs during battery
discharging.
● If this parameter is set to Disable, no
alarm is reported when battery
overcurrent occurs during battery
discharging.
Copyright © Huawei Technologies Co., Ltd.
5 Power-On Commissioning
Default Value
Value Range
8 8–3000
Default Value
Value Range
Disable Disable,
Enable
Enable Disable,
Enable
Enable Disable,
Enable
Disable Disable,
Enable
89