13.5. Vibration Strength
13.5.1. Vibration Test (in individual packaging))
There shall be no sign of malfunction of the scanner after the following vibration test.
Vibration Test: Increase the frequency of the vibration from 10Hz to 100Hz at an
accelerated velocity of 19.6m/s2 (2.0G) for 30 minutes (60 minutes for a cycle) in the non-
operating state. Repeat this in each X, Y and Z direction.
13.5.2. Vibration Test (without individual packaging)
There shall be no sign of malfunction of the scanner after the following vibration test.
Vibration Test: Increase the frequency of the vibration from 10 to 100 Hz with accelerated
2
velocity 19.6m/S
(2G) and sweep for 30 minutes (60 minutes in one cycle). Repeat this
routine in each X, Y, Z direction.
13.6. Dust and Drip Proof
IP-54
IEC60529
JIS C0920
13.7. Cable Strength
13.7.1. Cable Strength
No malfunctions occurred to the cable's performances after the following stretch tests.
Cable Strength Test: Affix the scanner to an immovable object and pull it using a force of
24.5N (2.5kgf static loading) for 1 second. Repeat this 20 times continuously.
13.7.2. Cable Bending Strength
No malfunctions occurred to the cable's performances after the following bending tests.
Cable Bending Test: Add a load of 4.9 N (500 gf) to a cable and bend it at an angle of 60°
to both right and left. Repeat this 1000 times continuously..
Figure 22: Cable Tail Bending Test
32
NLB / RLB-1000
Specifications Manual