Opticon NLB-1000 Specification Manual page 27

Default Settings 2: Read Options, Trigger, Buzzer
Item
Setting the number of characters
Read mode
Multiple read reset time
Add-on wait mode
*1
Redundancy
Inter-character gap check
Multiple columns read
Limitation of Decode Time
Read time
Buzzer durations
Buzzer tone
Buzzer loudness
Indicator duration (Green LED)
Code-39 minimum digit
NW-7 minimum digit
Industrial 2of5 minimum digit
Interleaved 2of5 minimum digit
MSI/Plessey minimum digit
(only when enabled)
*1
In case of the following symbologies ,because of the prevention of mis-decording , the reading
times is increased once and redundancy is also increased once .
● Code 39 with length <= 5
● MSI/Plessey with length <= 4
● IATA, Industrial 2of5, Interleaved 2of5 with length <= 8
● Codabar (NW-7) with all lengths
● Code 11 with length <= 5
*2
Refer to 12-4. Scanning Bar Codes on Moving Items
[U2] Communication Settings
Item
Baud rate
Start/stop bits
Data bits
Parity bits
Handshaking
Flow Control Time Out
Note: The communication condition can be changed by using the menu bar code.
Fixed length OFF all codes
Single read
500 msec
500 msec
Read 1 times, redundancy = 0 ([X0] setting)
Character 1>
Disable multiple columns read
*2
Disable
2seconds
50msec
2.6kHz
Loud (maximum)
200msec
1 digit
5 digits
5 digits
6 digits
3 digits
9600 BPS
1 bit
8 bits
No parity
No handshake
Indefinitely
27
Specifications Manual
Default Setting
Default Setting
NLB / RLB-1000