Centrifugal Clutch, Dismantling; Flywheel, Dismantling; Ignition Module, Dismantling; Dismantling, Centrifugal Clutch, Flywheel, Ignition Module - Husqvarna 525P4S Workshop Manual

Repair instructions
7.17 Dismantling the centrifugal clutch,
flywheel and ignition module
Remove the engine cover, clutch housing and
spark plug. Screw the stopper (special tool A) into
the plughole to fix the piston in place.Stopper 14
mm 514 24 39-01.
Remove the two screws holding the ignition
module and take away the earth cable.
Take out the clutch bolts and waved washers, and
remove the clutch. Clutch bolt width across flats
(WAF) 14mm.
Waved washer thickness 0.5 mm (black)
Unscrew the bolts to the ignition module.
Fig 2
A Clutch
B Clutch bolt
C Washer
D Waved washer
E Ignition module
46
- English
A
D
E
B
A
C