Husqvarna 525P4S Workshop Manual page 68

Repair instructions
Put the oil tank and the saw housing together. Do
not forget the oil filter (A). Make sure it is clean and
not damaged.
Make sure the tank venting filter (B) is clean.
Tighten the three screws.
Assembly the plastic cover and tighten the screw.
Assembly the washer, spur and the spring
washers. Make sure they are assembly in correct
order, see figure.
Tighten the nut. Make sure to counterhold on the
inner washer when tighten the nut, see figure.
8–10 Nm
Assembly bar and chain and the plastic cover (B).
tighten the nut (A)
Put the saw head on the shaft and tighten the nuts
(D, C).
Make sure the hole on the saw head align with
the hole on the shaft. Tighten screw D by hand to
make sure it fits in the hole in the shaft. Tighten the
screw.
68
- English