Centrifugal Clutch, Assembling; Flywheel, Assembling; Ignition Module, Assembling; Assembling, Centrifugal Clutch, Flywheel, Ignition Module - Husqvarna 525P4S Workshop Manual

Repair instructions
7.18 Assembling the flywheel, ignition
module and centrifugal clutch
1
When setting the key on the crankshaft, make
sure the end face of the key is parallel with the
crankshaft.
Fix the piston in place with the stopper (special
tool) and tighten the rotor nut.
Torque 15 Nm
Fig 10
A fly wheel
B Flywheel nut
2
Before installing the clutch, check the lining for
wear and replace with a new product if you find any
uneven wear, peeling, etc.
Make sure the spring is intact and not cracked.
Fig 1
A Clutch bolt
B Waved washer
C Arrow mark
D Clutch
E Washer
NOTE!
If there are any uneven gaps or the spring
is worn out or damaged between the
spring coil when the clutch is in closed
state, replace clutch shoe.
• Before installing, check for wear or rust on the
greased parts of the clutch bolts, the washers
and waved washers. Carefully remove any rust
and replace any badly worn parts with new parts.
• Install the clutch on the rotor with the arrow mark
on the clutch shoe facing the drum side.
• Apply molybdenum disulfide grease to the slide
surface between the clutch bolts and clutch shoe.
• Pay attention to the installation orientation of
the waved washers.
• Tighten the clutch bolts with the specified torque.
See Fig. Torque: 8 Nm.
48
- English
B
A
D
A
A
B
C
E