Ignition Module, Adjusting; Adjust The Air Gap When Installing Ignition Module - Husqvarna 525P4S Workshop Manual

7.7 Adjust the air gap when installing
the ignition module
1
Adjust the air gap as needed to the correct value.
• Loosen the bolts.
• Position the gauge to adjust the gap and press
the ignition module against the flywheel.
• Tighten the bolts and check the air gap again.
If the spark plug still does not fire, the ignition
system should be replaced.
Torque: 4.0 Nm.
Fig 5
A Rotor
B Gauge
C Ignition module
See Fig for Ignition module model (D) and
Article No (E).
Engine Ignition Module Resistance Value
Model module
525 UK08934 Primary (Iron
524 505 Core⇔Primary
Terminal):
80 kΩ±20%
Air Gap Gauge Model
No.
0.3 mm 514 22 10-01
The stated resistance value is only a guideline
figure when measuring with the tester. Internal
leaks and the like are not detected, even if a
resistance value is given. A gap tester is also
available as a measurement component, as a
spark tester for measuring the strength of sparking
even during engine operation. Fig to the left is a
3-core gap tester.
Secondary
(Iron
Core⇔High-
Voltage
Wire):
4 kΩ±10%
D
E
Repair instructions
C
A
B
35
English -