Telescopic Tube, Assembling (Pt5S); Assembling The Telescopic Tupe (Pt5S) - Husqvarna 525P4S Workshop Manual

Repair instructions
Loosen the screw holding the throttle control cover
(I).
Loosen the three screws (J) holding the clamping
sleeve.
Slide the throttle control cover and the clamping
sleeve off the telescopic tube. Separate the clam-
ping sleeve with a screwdriver if required.
Remove the screw (K) and pull out the pipe (L)
together with the rubber sleeve (M) from the
telescopic tube.
TIP!
Press a screwdriver in between the rubber sleeve
and the tube and spray with silicone to facilitate
dismantling.
Use a screw driver to press down the clip and pull
out the bearing and axle control.
Pull springs and ball bearings out of the telescopic
tube.
Remove the circlip (N), the ball bearing (O) and the
axle control (P) from the bearing cage (Q).
Note!
Note which direction the axle control (P)
is turned in the ball bearings and the tele-
scopic tube.
The axle control are always pointed to-
wards sawhead
7.30 Assembling the telescopic tube
(PT5S)
Assembly
Assemble the different components in the reverse
order as set out for dismantling.
First fit the axle control (P) in the ball bearing (in
the right direction) and then the ball bearing in the
bearing cage.
Then push the bearing cage into the rubber sleeve.
Slide the pipe (L) over the bearing cage and make
sure the spring tongues (A) on the bearing cage
snap in place on the tube.
Lubricate all components with a thin layer of
grease and continue assembling.
70
- English