Husqvarna 525P4S Workshop Manual page 64

Repair instructions
Remove the upper and lower clamp.
Remove the anti vibrations element
Note!
replace the antivibration element if it is
damaged or cracked.
Remove the small circlip from around the shaft on
the clutch drum using suitable circlip pliers. 515 41
95-01
Dismantle the clutch drum by using a specila tool,
581 44 10-01.
Dismantle the ring using a circlip pliers.
Dismatle the bearing using an appropriate punch
and hammer.
Assemble in the reverse order as set out for dis-
mantling. Use a press tool for installing bearing and
clutch drum.
Note!
Always use new bearings, if the clutch drum
is removed.
64
- English