Repair instructions
7.15 Assembling the carburetor
• Blow all channels in the carburetor compart-
ment clean
• Mount a new plug (A).
Use a suitable punch to get a completely tight
seal.
• Press in a new main jet (B).
• Mount the valves and springs.
Tip!
Any numbers on the valves should be able to be
read from the outside.
Make sure valves has a perfekt seal by locking at
the edge of the valve with tha carburetor backlit, a
light from the choke side.
Also make sure there are no clearence between
axial stop (e-clip in this case) and the carburetor
housing.
Replace the fuel screen if it is damaged or cannot
be cleaned.
Place the pump diaphragm closest to the
carburetor housing. Then the gasket and cover and
the other components in reverse order of removal.
42
- English
B
45°
Groove
A