Adjusting The Harness And Pole Saw - Husqvarna 327PT5S Operator's Manual

of 4 Nm. After the machine has been in use for around 20
hours, re-tighten the screws to 4 Nm.
A
Adjusting the harness and pole
saw
You should always use the harness with the machine to
give maximum control over the machine and reduce the
risk of fatigue in your arms and back. Adjust the harness
to suit the person's height. Move the support belt to a
suitable hole on the backplate.
• Put on the harness.
1153411-49 Rev. 8 2012-02-16
ASSEMBLY
• Adjust the shoulder straps to distribute the load evenly
across your shoulders.
• Tighten the chest strap under your left arm so that it
fits closely around your body.
• Pull out the support belt to the desired length.
–
English 17