Table of Contents
Advertisement
TROUBLESHOOTING
Phenomenon
Power is not turned on.
Error message "NO DISK" is displayed
on the monitor.
Error message "VIDEO LOSS" is dis-
played on the monitor.
Error message "TEMP ERROR" is dis-
played on the monitor.
Administrator password cannot be
remembered.
DISK MENU appears when turning on
the power.
Camera picture is not displayed on the
monitor.
Nine-split display does not function.
Setup menus supplied from the Matrix
Switcher are not recorded.
When accessing via the network:
Remote operations are not accepted
while BUSY indicator is lit.
Slow image refreshment and/or slow
response to operations
76
Cause
Insufficient power cord connections
There is no available disk.
Disconnection of camera, camera
cable, or VIDEO IN BNC.
Ventilation blocked, or failure of cooling
fan
HDD may have changed in status, or it
may have malfunctioned.
Lens cap is still left on the camera,
some device is not turned on, or bright-
ness and contrast of the monitor are
improperly adjusted.
QUAD ONLY may be set for MULTI
SELECT MODE.
The WJ-HD200 does not record non-
interlace video.
Front panel buttons on the recorder are
being operated, or more than four PC's
access the recorder.
Network is busy.
What to do
Connect the power cord to AC outlet.
Refer to HDD MAINTENANCE in
Appendix to confirm the HDD status.
Consult your dealer when a malfunction
is found.
Connect the respective camera, cable,
and connector properly.
Remove obstacles, or consult your
dealer for servicing.
Reset the recorder to the factory default
setting. (page 32)
Check the HDD status referring to HDD
MAINTENANCE. Consult your dealer
when a malfunction is confirmed.
Detach the lens cap, turn on the
device, or adjust the monitor.
Set it to ALL.
Wait until the preceding accesses end.
Wait until the preceding accesses end.
Advertisement
Table of Contents
