SETUP PROCEDURES
PRIOR TO SETUP
Turning On the Power
1. Plug the power cord into the AC outlet.
2. Turn on the power switch on the rear panel. The oper-
ate LED lights up. HDD check and system check will be
carried out while displaying respective messages.
Power-on recording will start if TIMER has been set to
EXT in the SYSTEM SETUP menu.
3. Press the [REC STOP] button to stop power-on record-
ing, if applicable.
POWER
ON
SIGNAL GND
OFF
4. Hold down the buttons of [LOCK] and [RESET] simulta-
neously to suspend alarm inputs. The SUSPEND indica-
tor will light up. This will help your setting operations not
to be interrupted by alarm inputs.
OPERATE
Note:
• Refer to Power-on Procedures in Appendix for
details.
21
ALARM
SUSPEND
OPERATE
RESET
SP
ALARM
TIMER
DST
MU
SUSPEND
REMOTE
RESET
LOCK
OSD
SEQUE
Turning Off the Power
1. Press the [STOP] button when playing back, or [REC
STOP] button when recording. Confirm that the HDD
access indicator has turned off.
2. Turn off the power switch on the rear panel. The oper-
ate LED goes off.
HDD
STOP
PLAY
REC
SETUP
/ESC
FULL
ALARM
SERCH
ERROR
PLAY MODE SELECT
Confirm that
HDD
STOP
the HDD access
SETUP
/ESC
FULL
indicator is off.
ALARM
SERCH
ERROR
PLAY MODE SELECT
Notes:
• Do not turn off the power while the HDD access
indicator is on.
• Do not leave the recorder for a long time. Supply
AC power to the unit and turn it on to charge up the
backup battery.
PUSH— PAUSE
SET
REC STOP
TIME&DATE
SEARCH
ALARM
RECALL
Digital Disk Recorder WJ-HD200
PLAY
REC
REC STOP
TIME&DATE
SEARCH
AL
RE
POWER
ON
SIGNAL GND
OFF