Table of Contents
Advertisement
System Information
SYSTEM INFORMATION
SYSTEM INFORMATION
HDD1 HOUR METER
HDD2 HOUR METER
HDD CAPACITY
DEFAULT
SYSTEM VERSION
SYSTEM LOGO
HDD Hour Meter HDD HOUR METER
The meter shows how many hours each hard disk has been
operated in playback, recording and idle. The built-in HDD
needs replacement when the hour meter reads around 30
000 H.
HDD Capacity HDD CAPACITY
The total usable capacity of the built-in hard disk is indicat-
ed.
Default DEFAULT
This enables the recorder to restore all setup data to the
default values.
1. Press the JogDial to move the cursor to DEFAULT.
2. When the cursor is on SET , press the JogDial again.
3. Select YES or NO with the JogDial, and press the
JogDial.
The default is NO.
NO: Current setup data is retained.
YES: Current setup data is reset to the default values.
When all setup data are reset to the default, "SET
DONE" is displayed for a few seconds, and it turns to
SET .
Note: The recorder will restart when the network setup has
been changed and the menu is closed.
System Version SYSTEM VERSION
This line displays the version number of the installed sys-
tem software. Version number will help you when updating
the software.
41
10000H
10000H
135.95G
SET
X.XX
System Log SYSTEM LOG
The system log is listed on the monitor with event number,
date, time, and cause.
SYSTEM LOG (1 OF 10)
NO.
DATE
99 FEB28.03
98 FEB28.03
97 FEB20.03 10:10:23 HD2
96 FEB15.03 23:50:42 RV1
95 FEB11.03 23:52:10 EMP
94 JAN31.03 19:43:32 THE
93 JAN30.03 19:50:14 LS1
92 JAN15.03 19:52:54 TM2
91 JAN10.03 10:40:22 TM4
90 JAN01.03 10:50:20 LS1
Abbreviation
Cause
THE
Thermal error
WR1
Writing error
WR2
RV1
HDD automati-
cally removed
RV2
S.M.A.R.T
HD1
detects on
HD2
error on HDD.
EMP
HDD empty
TM*
ALM
VM*
VMD
LS*
LOSS
PC*
PC
POW
Power
ERR
Error
TIME
CAU
6:50:06 WR1
5:23:51 HD1
Description
Temperature exceeds the
operating range.
Writing error on HDD
Master HDD
Slave HDD
Master HDD
Slave HDD
Warning, HDD is nearing to
the end.
Terminal alarm event was
logged, but no picture
recorded. * = 1-8
VMD event was logged, but
no picture recorded. * = 1-8
Video input loss on channel
# (*). * = 1-8
Alarm has been input from
the PC.
Power disconnection due to
electricity failure/trouble has
been detected.
Errors other than shown
above
Advertisement
Table of Contents
