Main Menu Wj-Hd200 Main Menu; Timer Recording Setup Timer Rec - Panasonic WJ-HD200 Operating Instructions Manual

Main Menu WJ-HD200 MAIN
MENU
The main menu is located in the top of the menu tree from
where every menu window starts.
WJ-HD200 MAIN MENU
TIMER
O
REC SETUPO
EXT REC SETUPO
DISPLAY SETUPO
SYSTEM SETUPO
ALARM SETUPO
COMMUNICATION SETUPO
SWITCHER SETUPO
SYSTEM INFORMATIONO
1. Hold down the [SETUP/ESC] button for 2 seconds. The
main menu appears.
2. Select a setup menu you wish to program using the [D]
or [C] button, and press the [SET] (JogDial).
The selected setup menu opens. The following pages
will detail each setup menu.
Timer Recording Setup TIMER
REC
This menu assigns a timer to start recording by use of an
external timer or the internal timer. When the internal timer
(INT) is set, there are four programs assignable to the
weekly and/or daily schedule. Each program can contain
up to four events along with start and end time, recording-
mode. Alarm recording will be carried out when an alarm
operates during the scheduled time zone.
When the external timer (EXT) is set and the connected
timer switch turns on to supply power, the recorder will start
power-on recording.
1. Select a timer mode using the JogDial.
OFF: Does not use any timer, and manual recording is
available.
INT: Carries out internal timer recording according to
the program.
EXT: Carries out power-on recording.
2. Press the JogDial to validate the selection. When INT is
selected, the TIMER REC menu opens.
TIMER REC
SUNDAY
MONDAY
TUESDAY
WEDNESDAY
THURSDAY
FRIDAY
SATURDAY
DAILY
25
OFF
PROGRAM
PROG1O
3. Move the cursor to the desired line using the [D] or [C
] button.
4. Select a program number from among PROGRAM 1 to
PROGRAM 4 using the JogDial, and press the JogDial.
The PROGRAM "1-4" SETUP menu opens.
Program "1-4" Setup PROGRAM "1-
4" SETUP
PROG1 SETUP
NO. START END
1 8:00 12:20
2 13:00 15:00
3 : :
4 : :
1. Select the event number with the [D] or [C] button,
and press the JogDial. The cursor moves to the START
position.
After this operation, the [D] and [C] buttons move the
cursor to the right and left.
2. Select a start time (START) using the JogDIal, and
press the [D] button to move the next position.
Available START time: From 0:00 to 23:59 in the 24-
hour system.
3. Select an end time (END) in the same way as above
and press the [D] button to move the cursor to the
MODE position.
Available END time: From 0:01 to 24:00 in the 24-hour
system.
Notes: There are some restrictions on programming.
• An event, except the first event (NO 1), can be pro-
grammed only if the immediately preceding event
has been set up.
• A start time should be late than the end time of the
immediately previous event.
• An end time should be late than the start time of the
event.
• An end time 24:00 will cancel all the following
events.
4. Press the JogDial while the cursor is on SETO to open
the event programming menu.
MODE
SETO
SETO