Table of Contents
Advertisement
8 Password Operation (PASSWORD OPERATION)
Enter a five-digit password to protect normal operations
from unauthorized access.
Available numerals: From 11111 to 88888
8 Keylock Buzzer (KEYLOCK BUZZER)
The buzzer will beep or not when a locked button is
pressed.
ON: Enables the buzzer to beep.
OFF: Disables the buzzer to beep.
8 Skip Alarm Recall (SKIP ALARM RECALL)
Specify a skipping page number of the alarm log. The
alarm log page will jump the specified pages when the
JogDial is rotated.
Available skip page: From 1 to 5
8 Simultaneous Recording and Playback
(SIMULTANEOUS REC&PLAY)
There may be cases where recording is essential
although during playback.
ON: Allows both recording and playback at a time.
OFF: Allows exclusively recording or playback.
Note: The recording rate may be sacrificed in the following
cases.
• Recording and playback/FTP access are simultane-
ously carried out.
• A multi-split screen is displayed.
• VMD (video motion detection) is enabled.
• A PC accesses the live images via the network.
8 Alteration Detection ALTER DETECT
You can enable or disable the recorder to add alter-
ation-detection signals in the JPEG data supplied to the
network. The default is OFF.
ON: Detects alterations.
OFF: Does not detect.
Note: When set to ON, the data transmission rate on
the network will slow down.
8 Disk End Mode DISK END MODE
STOP: Stops recording until a mode other than [STOP]
is selected.
CONTINUE: Old data is automatically overwritten from
the disk start.
8 Disk End Buzzer DISK END BUZZER
ON: Enables the buzzer beep at the disk end (remain-
ing space = 0 %).
OFF: Disables the buzzer beep.
62
8 Play Priority PLAY PRIORITY
This setting places priority on a specific access point
for playing back the image data when access collisions
take place.
LOCAL: Places priority on the front panel operations.
NET PLAY: Places priority on the network access.
FTP GET: Places priority on the access to the FTP.
NONE: The latest operation has priority than others.
8 Time Adjusting (TIME ADJUSTING)
The internal timer built in the WJ-HD200 is calibrated
once a day via the Time Adjust In and Out terminals on
the rear panel.
SLAVE: Accepts the calibration signal from the master.
MASTER: Supplies the calibration signal to the slave
units at the specific hour a day.
Advertisement
Table of Contents
