Table of Contents
Advertisement
CAM1
Notes:
• VMD should be used with an ordinary camera input
to the unit. Select [OFF] to avoid useless VMD when
a video multiplexer or combination camera supplies
the input to the unit.
• Set the ALARM SUSPEND to ON when VMD is
unnecessarily activated during the VMD setup.
4. Set the upper-left end of the detection area. Move the
asterisk to the right or left with the JogDial, and up or
down by pressing the [D] or [C] button.
REW/FF
/
STEP
/
PUSH
/
5. Press the JogDial to enter the upper-left end of the
detection area. The asterisk position is highlighted.
6. Set the bottom-right end of the detection area similar to
steps 3 and 4 above.
7. Press the JogDial. The area is highlighted.
Up to 4 areas can be selected. These may partially
overlap. Repeat steps 3 to 6 to select more areas. To
deselect an area, move the cursor to the upper-left end
of the area, and press the JogDial.
q
36
*
PAUSE
SET
•
/
e
w
r
Communication Setup
COMMUNICATION SETUP
Communication parameters are set to match those of the
connected devices and the system configuration. The serial
port setup and network setup are made.
COMMUNICATION SETUP
SERIAL SETUPO
NETWORK SETUPO
Serial Setup SERIAL SETUP
The SERIAL SETUP menu appears when it is selected in
the COMMUNICATION SETUP menu.
SERIAL SETUP
PROTOCOL
BAUD RATE
DATA BIT
PARITY CHECK
STOP BIT
WAIT TIME
CTL-UNIT ADDR 1
SYS-UNIT ADDR 1
ALARM DATA
CAM NO.SETUPO
Note: Parameters marked with * in the following pages are
default settings applied to VCR.
Protocol PROTOCOL
1. Move the cursor to PROTOCOL with the [D] or [C] but-
ton.
2. Select a suitable protocol with the JogDial, and press
the JogDial.
The default is PS
DATA.
•
PS
DATA: Select when the communication chain uses
•
the PS
DATA protocol.
•
This selection enables the DATA terminal on the
rear panel for communication.
VCR: Select when other than PS
This selection enables the RS-232C terminal on the
rear panel for communication.
Note: Parallel use of the DATA and RS-232C terminals
is not possible.
PS•DATA
9600
8
NONE
1
OFF
1S
DATA is used.
•
Advertisement
Table of Contents
