Table of Contents
Advertisement
INITIALIZING
You can initialize either all disk contents including image
data and setup data.
Initializing All Contents & Setup Data
Warning! The following are irrevocable procedures. We
strongly recommend that you copy important pictures
from the hard disk.
ON
1 2 3 4 5 6
1. Press the [REC STOP] button on [STOP] button to stop
recording or playback.
2. Turn off the power.
3. Set MODE switches #1 through 4 on the rear panel as
follows:
#1: ON
#2: OFF
#3: OFF
#4: ON
4. Turn on the power.
The disk contents and setup data are initialized.
NOW FORMATTING HDD
Note: When finished, the monitor will display the cam-
era image and status information while the indicator
on the selected CAM SEL button is lit. Be sure to
carry out the next step, #5.
5. Turn off the power, and return the MODE switches to
the previous positions. Then, turn on the recorder.
24
ON
OFF
MODE
Initializing Setup Data
SYSTEM INFORMATION
HDD1 HOUR METER
HDD2 HOUR METER
HDD CAPACITY
DEFAULT
SYSTEM VERSION
SYSTEM LOGO
1. Open the SYSTEM INFORMATION window, then move
the cursor to DEFAULT.
2. Press the JogDial to move the cursor to SET.
3. Press the JogDial.
4. Select YES with the JogDial.
YES: Initializing of setup data is enabled.
5. Press the JogDial.
SET DONE appears on the monitor after initializing.
6. Press the [SETUP/ESC] button.
The cursor moves to DEFAULT.
7. Hold down the [SETUP/ESC] button for 2 seconds to
quit the setup.
Note: After closing the setup menu, the system may
automatically restart if any parameter on the net-
work has been changed.
10000H
10000H
135.95G
SET
X.XX
Advertisement
Table of Contents
