Table of Contents
Advertisement
Pressing REC STOP Button
Pressing the [REC STOP] button resets alarm status and
recording when MONITOR MODE is set to OFF. When
SPOT is set, only the [ALARM RESET] button will reset
alarm status and recording.
Suspending Alarm Input
This function may be convenient during setup procedures.
When enabled, any alarm input is ignored and the recorder
performs as follows.
• The alarm event will be stored in the alarm log.
• The recorder enters alarm recording.
• The alarm buzzer does not sound.
• The SUSPEND indicator lights up.
1. Hold down the alarm [RESET] button and [LOCK] but-
ton simultaneously to enable the suspension function.
The SUSPEND indicator lights up.
2. Do as same as above to reset the suspension function.
The indicator turns off.
46
REC STOP
ALARM
TIMER
SUSPEND
REMOTE
RESET
LOCK
Alarm Log Recall & Search
The ALARM RECALL window lists the alarm event log in
chronological order with event number, date, time, and the
activation source. A maximum of 2 000 events can be
stored.
ALARM RECALL
NO.
DATE
1543 OCT30 23:58:12
1542 OCT30 23:52:54
1541 OCT30 23:40:29
1540 OCT30 23:39:50
1539 OCT30 23:35:41
1538 OCT30 23:30:22
1537 OCT30 23:25:55
1536 OCT30 23:21:09
(TOTAL
1543EVENTS)
TO SEARCH PUSH T&D KEY
ALARM RECALL
NO.
DATE
0003 OCT20 23:52:54
0002 OCT20 23:51:54
0001 OCT20 23:50:54
PUSH JOG DATA CLEAR.
(TOTAL
1543EVENTS)
TO SEARCH PUSH T&D KEY
T: Alarm terminal was activated.
V: VMD was activated,
P: PC notified an alarm event.
Note: In some cases the log displayed in the ALARM
RECALL list may apply to the previous alarm record
that was overwritten after selecting CONTINUE for the
DISK END MODE. This is because the alarm log is
updated later than the image data.
To brows through the log
1. Hold down the JogDial for 2 seconds. The monitor dis-
plays the ALARM RECALL list.
2. Rotate the JogDial to scroll up or down the page.
Scrolling speed is selected in the menu setup.
3. Hold down the JogDial for 2 seconds to quit the ALARM
RECALL list and go back to the previous window.
To sort by channel
1. Hold down the JogDial for 2 seconds to display the
ALARM RECALL list. The log of the all channel appears.
2. Press the desired channel [CAM SEL] button. The indi-
cator on the button lights up, and only the log of the
selected channel will be displayed.
3. Press another channel button to select a new channel.
4. To return to the all-channel list, press the button of the
selected channel (now being lit) or the [MULTISCREEN
SELECT] button.
YEAR03
TIME
ALM
T1
V2
V3
T4
L2
L1
T2
T2
YEAR03
TIME
ALM
V2
V2
V2
Advertisement
Table of Contents
