I System Information (System Information) - Panasonic WJ-HD200 Operating Instructions Manual

I System Information
(SYSTEM INFORMATION)
SYSTEM INFORMATION
HDD1 HOUR METER
HDD2 HOUR METER
HDD CAPACITY
DEFAULT→
SYSTEM VERSION
SYSTEM LOGO
G HDD Hour Meter (HDD HOUR METER)
The meter shows how many hours each hard disk has been
operated in playback, recording and idle. The built-in HDD
needs replacement when the hour meter reads around
30 000 H.
G HDD Capacity (HDD CAPACITY)
The total usable capacity of the built-in hard disk is indicat-
ed.
G Default (DEFAULT)
This enables the recorder to restore all setup data to the
default values.
1. Press the JogDial to move the cursor to DEFAULT.
2. When the cursor is on SET→, press the JogDial again.
3. Select YES or NO with the JogDial, and press the
JogDial.
The default is NO.
NO: Current setup data is retained.
YES: Current setup data is reset to the default values.
When all setup data are reset to the defaults, "SET
DONE" is displayed for a few seconds and then
changes to SET→.
Note: The recorder will restart when the network setup has
been changed and the menu is closed.
G System Version (SYSTEM VERSION)
This line displays the version number of the installed sys-
tem software. You will need the version number when
updating the software.
10000H
10000H
228.99G
SET→
X.XX
G System Log (SYSTEM LOG)
The system log is displayed on the monitor with event num-
bers, dates, times, and causes.
SYSTEM LOG (1 OF 10)
NO. DATE
99 FEB28.03
98 FEB28.03
97 FEB20.03 10:10:23 HD2
96 FEB15.03 23:50:42 RV1
95 FEB11.03 23:52:10 FLL
94 JAN31.03 19:43:32 TML
93 JAN30.03 19:50:14 LS1
92 JAN15.03 19:52:54 FL%
91 JAN10.03 10:40:22 TM4
90 JAN01.03 10:50:20 LS1
Abbreviation Cause
TML Thermal error
WR1
Writing error
WR2
RV1
HDD automati-
cally removed
RV2
S.M.A.R.T
HD1
detects an
HD2
error on HDD.
FL% HDD XX%
FLL HDD FULL
TM* ALM
VM* VMD
LS* LOSS
PC* PC
POW Power
ERR Error
TIME CAU
6:50:06 WR1
5:23:51 HD1
Description
Temperature exceeds the
operating range.
Writing error on HDD
Master HDD
Slave HDD
Master HDD
Slave HDD
Warning, HDD is nearing to
the end.
HDD is FULL.
Terminal alarm event was
logged, but no picture
recorded. * = 1-8
VMD event was logged, but
no picture recorded. * = 1-8
Video input loss on channel
# (*). * = 1-8
PC alarm was logged, but
no picture recorded. * = 1-8
Power disconnection due to
electricity failure/trouble has
been detected.
Errors other than shown
above
41