Software Settings; Clock Settings - Renesas QB-78K0FX2L User Manual

QB-78K0FX2L In-Circuit Emulator

2.1 Software Settings

Check the user's manual for the debugger that will be used.

2.2 Clock Settings

The IECUBE clock must be set to the clock used by the target device. For details about how to set the clock, check the
user's manual for the debugger that will be used.
IECUBE clock settings for the clock used by the target device are shown below.
Oscillation with the resonator on the target system is not supported. Therefore, the in-circuit emulator cannot emulate
the oscillation operation of the clock on the target system.
Clock Used
(1) High-speed system clock
(X1 oscillator or External input)
(2) Internal high-speed
oscillation clock
(3) Internal low-speed
oscillation clock
R20UT2057EJ0100 Rev.1.00
2012.05.18
Table 2-1. List of clock settings
(a) When the clock generated within the emulator is used
(b) When the clock (a square wave) is supplied from the target system
(c) When the oscillator (OSC1) mounted onto the emulator is used
Uses the clock internally generated from the emulator
Uses the clock internally generated from the emulator
CHAPTER 2 SETUP PROCEDURE
Clock Supply
Page 19 of 37