Table of Contents
Advertisement
QB-78K0FX2L In-Circuit Emulator
1.3 System Specifications
This section shows the QB-78K0FX2L system specifications.
Parameter
Emulation memory capacity
Program execution
functions
Memory manipulation
Register manipulation
Disassemble function
Local variable view
Watch data view
Stack trace view
Break functions
Trace functions
Real-time RAM monitoring function
Time measurement
functions
Other functions
R20UT2057EJ0100 Rev.1.00
2012.05.18
Table 1-4. QB-78K0FX2L System Specifications
Internal ROM
Internal RAM
Real-time execution function
Non-real-time execution function Step In, Next Over, Slowmotion, Go & Go
Event break
Software break
Hardware break
Fail-safe break
Other
Trace data types
Trace modes
Trace functions
Memory capacity
Measurement clock
Measurement objects
Maximum measurement time
Number of timers for
measurement
Measurement results
Other
Specification
512 KB (MAX.)
61KB (MAX.)
Go, Start from Here, Come Here, Restart, Return Out,
Ignore break points and Go
Available (initialize, copy, compare)
Available (general-purpose registers, control registers, SFRs)
Available
Local variables
Local variables, global variables, or else
Available
Execution: 8 points
Access: 10 points
(exclusively for bytes: 8 points, exclusively for words: 2 points)
2000 points
Before execution:
16 points
After execution:
8 points
Access:
10 points
Non-map, write protect, SFR illegal access, stack overflow, or else
Forcible break, trace full break, trace delay break, timeout break,
timer overflow break
Program address, program data, access address, access data,
status, time tag
Unconditional trace, section trace, qualify trace, delay trigger trace
Non-stop, full stop, full break, delay trigger stop, delay trigger
break
128K frames
All internal RAM spaces
50 MHz (Minimum resolution: 20 ns)
Start through end of program execution
Start event through end event
Approx. 48 hours and 50 minutes (Resolution: 41
Start through end of program execution: 1
Start event through end event: 2
Execution time (start through end of execution)
Maximum, minimum, average, total, pass count (between events)
Timer overflow break function, timeout break function
Command functions set in the console, mapping function,
event function, coverage function, snapshot function, DMM
function, power-off emulation function, pin mask function,
flash self programming emulation function
CHAPTER 1 GENERAL
s)
Page 12 of 37
Advertisement
Table of Contents
