Renesas QB-78K0FX2L User Manual page 11

QB-78K0FX2L In-Circuit Emulator
(1) TCN1, TCN2
These are connectors for connecting a check pin adapter or emulation probe.
(2) OSC1
This is a socket for mounting the oscillator.
(3) CN4/JP1
This is a connector for the shipment inspection. It is not something that the user will need.
(4) POWER (Red LED)
This is an LED that shows whether the power supply of the QB-78K0FX2L is switched on.
LED State
Lit
Not lit
Blinking
(5) TARGET (Green LED)
This is an LED that shows whether the power supply of the target system is switched on.
LED State
Lit
Not lit
(6) Power switch
This is the power switch of the QB-78K0FX2L.
It is OFF at shipment.
R20UT2057EJ0100 Rev.1.00
2012.05.18
Table 1-2 POWER(Red LED) LED
Power switch ON
Power switch OFF or AC adapter not connected to QB-78K0FX2L
Internal error occurred (Contact an Renesas Electronics sales representative or
distributor)
Table 1-3 TARGET (Green LED)
Target system power supply ON
Target system power supply OFF or target system not connected
QB-78K0FX2L State
Target System State
CHAPTER 1 GENERAL
Page 11 of 37