Software Settings - Renesas QB-78F1030 User Manual

QB-78F1030
(3) Subsystem clock
The clock settings are listed below.
(a) When the clock generated within the emulator is used
(b) When the clock is supplied from the target system
Note This setting is not possible when TARGET LED is not lit.
Remark Settings other than above are prohibited.
(a) When the clock generated within the emulator is used
Select the "System" in the debugger and select "32.768" [kHz] as the frequency from the drop-down list.
32.768 [kHz]
Remark
(b) When the clock is supplied from the target system
Select the "External" in the debugger. The clock input from the target system is then used.
Oscillation with the resonator on the target system is not supported. To input a clock from the target
system, input to the clock pin (XT2) the square-wave signal with the same voltage potential as that of the
target device supply voltage (V
The selectable frequencies are same as those of the target device.
2.4

Software Settings

For details, see the ID78K0R-QB Ver. 3.61 Integrated Debugger Operation User's Manual (R20UT0001E).
R20UT0289JJ0100 Rev. 1.00
Sep 30, 2010
Table 2-2. Settings for Subsystem Clock
Type of Clock to Be Used
"38.400" [kHz] can also be selected from the list, but do not select this frequency; it is not
supported by the device.
). Inputting the inverted signal to XT1 is not necessary.
DD
CHAPTER 2 SETUP PROCEDURE
Debugger Setting
System
Note
External
Page 16 of 28