Table of Contents
Advertisement
DMX Address Setting
Select the
, press the ENTER button and the display will blink. Use the UP/DOWN button to
adjust the address between
press the ENTER button to setup or automatically exit menu mode without any change after 7
seconds. Back to the previous functions without any change press the MENU button.
Channel Mode
Select the
, press the ENTER button and the display will blink. Use the UP/DOWN button
to select the
Green, Blue, White, Dimmer) or
Strobe). Once selected, press the ENTER button to store or automatically exit menu mode without
any change after 7 seconds. To go back to the functions without any change press the MENU
button.
Show Mode
Select the
, press the ENTER button and the display will blink. Use the UP/DOWN button
to select the
the ENTER button to setup. Press the ENTER button，
UP/DOWN button to adjust the fade time (0~255), press the ENTER button to store and
will blink on the display, use the UP/DOWN button to adjust the wait time (0~255), press the
ENTER button to store or automatically return to the main functions without any change after 7
seconds. To go back to the previous functions without any change press the MENU button.
Select the
button to select the
or
(Manual Mode). Once selected, press the ENTER button to setup or automatically
exit menu mode without any change after 7 seconds. To go back to the functions without any
(4 Channels: Red, Green, Blue, White),
(Show 1),
DMX State
, press the ENTER button and the display will blink. Use the UP/DOWN
(Primary Secondary),
and
. Once the address has been selected,
(7 Channels: Red, Green, Blue, White, Color, Dimmer,
(Show 2)....
8D
(5 Channels: Red,
(Show 16). Once selected, press
will blink on the display, use the
(Blackout),
(Last State)
Advertisement
Table of Contents
Need help?
Do you have a question about the Building Wash and is the answer not in the manual?