Operation - Feider Machines FP225-KET User Manual

3. OPERATION

WARNING
While working with this tool, the dust caused can be dangerous to one's health:
While working with a sander always wear eye protection and a dust mask.
Do not work with material containing asbestos. Asbestos is known to cause cancer.
Special caution while sanding material containing lead:
All persons, that are working with the machine or entering the workspace, must wear a special mask for
protection from lead colors and steam.
Children and pregnant women are not allowed to enter the workspace.
At the workspace, it is not allowed to eat, drink or smoke. Contact with or inhaling of the sanded dust (for ex.
Lead-based coating material) can cause the user and others present damage to their health.
YOU SHOULD ALWAYS
Always wear proper size personal protection equipment such as a dust mask and use while sanding with a
dust bag.
The power cable must be kept away from the moving parts of the machine.
Wear protection goggles, especially while sanding above one's head.
ABRASIVE DISC SELECTION
The Drywall Sander is shipped with 6pcs of sanding paper ((80/100/120/150/180/240grit). This abrasive is
suitable for most applications. Abrasive discs of 120 grit and 240 grit are available for situations requiring a
smoother finish.
INSTALLATION
Before the repair or replacement parts, electric tool accessories, be sure to pull out the plug from the socket
THE REPLACEMENT OF ABRASIVE SANDING PAPER
Before installing the new sanding paper, must first clear up the sanding disc, such as the use of brush.
Sanding pad has a layer of cloth; it can quickly and easily install flocking self-adhesive sandpaper. Place the
new sanding disc accurately onto the sanding pad. Press it firmly by hand into place.
DO NOT USE THE SANDER WITHOUT A PROPER ABRASIVE SANDING PAPER INSTALLED (to
prevent severe damage to the work).
ABRASIVE PAD REPLACEMENT
CAUTION: DISCONNECT SANDER FROM POWER SOURCE.
1). Grasp the abrasive belt and strap support (tighten the plate on the bracket), to prevent rotation.
2). Rotate the insert retaining nut counter clockwise and remove it..
3). Lift the large metal washer and the abrasive pad.
NOTE: When the abrasive pad is removed from the sander, the abrasive rear disc is exposed. This rear disc
is also covered with an abrasive material.
This abrasive material is ONLY used to prevent "slippage" between the rear disc and the back abrasive plate
foam. It is NOT suitable for use as an abrasive sander. NEVER USE THE SANDER WITHOUT PROPER
ABRASIVE PAD INSTALLED (to prevent severe damage to the work).
08