Table of Contents
Advertisement
3.
ASSEMBLY
3.1 Installation of the auxiliary handle (B2)
Warning! This appliance must not be used without an auxiliary handle.
Mount the auxiliary handle on the machine. Tighten it with the two screws (B2, 6).
The tilt of the auxiliary handle can be adjusted so that the guide hand is in a good working posture for certain
applications.
- Loosen the two screws and tilt the auxiliary handle to the desired working position.
- Tighten the screws.
3.2 Installation of the sanding plate or diamond wheel
Note: Wear gloves when changing the tool. There is a risk of injury from contact with removable tools. The
device must be switched off and unplugged before assembly and disassembly.
- Check that the flange is properly installed on the appliance (see B3).
- Place the sanding plate or the diamond wheel on the flange (see B4).
- Put and screw the screw in place. Then push in the spindle stop and tighten the screw with the wrench (See B5 and
B6).
To remove the installed accessory, push the spindle stop and loosen the screw with the wrench. Then remove the
screw to be able to disassemble the installed accessory.
3.3 Installation of the suction hose (B8)
Warning! Use the suction hose provided for suction.
- Push the suction hose into the appliance opening until it clicks into place.
- For disassembly, turn the suction hose, and then separate the components.
4.
OPERATION
4.1 Start / Stop (B9)
In order to save energy, do not switch on the power tool until it is in use.
Plug the tool to electrical alimentation.
- To switch on the power tool, press the ON/OFF forwards. To block the ON/OFF button, press the ON/OFF button (7)
until it locks.
- To stop the power tool, release the ON/OFF button or when it is blocked, press the ON/OFF button briefly, then
release it.
4.2 Adjusting the speed of rotation (B10)
The rotary speed selection adjustment wheel allows you to preset the required rotational speed even during operation.
The required rotation speed depends on the part and the working conditions. It can also be determined by a practical
test.
4.3 Inserting and changing the sandpaper (B7)
Note! Make sure not only to stop the device but also to disconnect it from the power supply
before inserting or removing the sandpaper.
In order to be able to change the sandpaper, place the appliance on a flat support. Remove the sandpaper from the
tool box and fix it on the sanding pad. The back side of the sandpaper (9) automatically sticks to the plate /
to the sanding plate with a Velcro strip and thus establishes a connection and a thermal conductivity.
For optimal sanding results, the sandpaper should be replaced after a period of use. To do this, first stop the device
and disconnect it from the power supply. Then remove the old sandpaper completely from the plate so that you can
comfortably insert new sandpaper and thus facilitate the
subsequent replacement. Finally, put the new sandpaper in position.
12
Advertisement
Table of Contents
