Gobo Replacement - ADJ VIZI BSW 300 User Instructions

G O B O R E P L A C E M E N T
The glass gobo's are the only gobo's that are interchangeable in this unit. Remember when changing
these gobo's they are glass. This process must be done carefully so as not to break the gobo.
Note: There is one metal gobo in this wheel which is also interchangeable.
Caution! Never open the unit when in use. Always disconnect the main power before attempting to
change the gobos.
Locating the Gobo wheel: After disconnecting the main power, position the head with the lens facing
forward. Look through lens of the unit. When looking through the front lens, position the head so that the
gears are on the right side. When the gears are on the right side, the shell that needs to be uscrewed
is now facing up.
1. To change a gobo, uscrew the 4 screws that secure the shell to the unit. The shell is attached to the unit by
a safety wire, gently lift the shell off of the unit.
2. When you remove the shell you will be able to access the gobo wheel. Turn the wheel with your hand until
you come across the gobo you would like to change.
3. You have to remove the individual gobo frames. Gently push the gobo frame (Not the wheel) away from
the gobo wheel, you do not have to the push the gobo frame to far. While you are pushing the gobo frame
away from the wheel, pull the gobo frame up and out.
4. Once the gobo frame has been removed, you will notice that high temperature silicon is applied to the
retainer ring. Using a small flat head screw driver, very gently scrape away the silicon to release the
retainer ring. After the retainer ring is removed, remove the gobo.
5. Change the gobo and replace the retainer ring. Reapply high temperature silicon or high temperature
gasket sealer to the same areas on the retainer ring.
6. Insert the gobo frame back into the unit, positioning it in same way as the other gobo frames.
7. Reassemble the unit.
12