Advertisement
7 Guide Sleeve, Dust Excluder, Retainer and Bush
Fig. 61
Fig. 62
Fig. 63
Fitting New Dust Excluder Retainers (13)
Using ArvinMeritor Service tool MBT1000, place Retainer (13)
onto suitable arbor Fig. 61
G - Fitting Guide Sleeve Retainer (13) Oval Bush -
Short Guide Sleeve
Place retainer onto the housing and with remaining applicable
parts of the service tool, draw the retainer into the guide sleeve
bore until the flat face of the retainer is between 4.65 to 5.15mm
from the end of the guide sleeve bore. Fig 62
WARNING
Do not apply excessive force when pulling the retainer into
the bore as this may result in damage to the bush or
retainer.
H - Fitting Guide Sleeve Retainer (13) -
Long Guide Sleeve
Place retainer onto the housing and with remaining applicable
parts of the service tool, draw the retainer into the guide sleeve
bore until the flat face of the retainer is between 4.65 to 5.15mm
from the end of the guide sleeve bore. Fig 63
I - Dismantling Guide Sleeves (24,26) & Dust Excluders
(12) – Long and Short Guide Sleeves
Carefully detach the guide sleeve dust excluders from their
location on the carrier and slide off the guide sleeves. – Fig. 64
Fig. 64
ArvinMeritor Air Disc Brake ELSA 195
41
Advertisement
