Advertisement
5 Housing assembly replacement
A - Removing the Housing assembly
Support the vehicle and remove the air actuator as described in
the section 3 "Brake replacement".
Remove the pads as described in section 2 "Pad replacement".
Remove the bridge as described in section 4 "Bridge
replacement".
Carefully slide the housing off the guide sleeves (24, 26), which
are secured to the carrier. Fig. 23
Clean and inspect the carrier for signs of damage or wear paying
particular attention to the pad abutment areas and guide sleeves
(24, 26). Fig. 24
Fig. 23
guide sleeve
pad abutment
Fig. 24
28
ArvinMeritor Air Disc Brake ELSA 195
If any doubt exists as to the suitability for further service replace
with new guide sleeves (24, 26) and if necessary a new carrier (2)
Clean and inspect the brake rotor as described in the section 2
"Pad replacement".
B - Fitting Housing assembly
Fit new guide sleeve dust excluders (12) over the guide sleeves
ensuring that the dust excluder bead is correctly located correctly
on the retainer (13) fitted to the carrier. Fig. 25 and 26
Fig. 25
Fig. 26
Advertisement
