R&S QAT100 User Manual page 24

®
R&S QAT100
2. Connect the Tx connectors to the "Tx IF Out" of the radar echo generator.
There are two ways to use the Tx connectors:
●
●
3. Connect the Rx antennas to the "Rx IF In" of the radar echo generator as required.
Keep in mind that the receive antennas always receive the signal.
If you want to feed only a single receive signal into the radar echo generator, con-
nect the "Rx Select" to one "Rx IF In".
You can also use the "Rx Select" connector to connect other external devices like a
spectrum analyzer.
4. Connect the frequency reference (input or output) to the radar echo generator if
you want to synchronize the reference frequencies.
For more information about configuring the interaction between R&S QAT and
radar echo generator, refer to the user documentation of the radar echo generator.
User Manual 1179.3073.02 ─ 02
Variant 1:
Connect the transmit signal to the "Tx ∑" connector. In that case, all transmit
antennas share the same signal.
Tx Out
Rx Out
Variant 2:
Connect the transmit signal to the "Tx A" to "Tx D" connector. In that case,
each antenna segment can transmit a different signal.
Tx Out
Rx Out
Tx Out
Rx Out
Tx Out
Rx Out
Tx Out
Rx Out
Simulating radar objects
Tx ∑
Rx E
Tx A
Rx A
Tx B
Rx B
Tx C
Rx C
Tx D
Rx D
24