Setting Up The Product; Placing The Product On A Bench Top - R&S QAT100 User Manual

®
R&S QAT100
If class A equipment causes radio disturbances, take appropriate measures to
eliminate them.

3.4 Setting up the product

See also:
●
"Setting up the product"
●
"Intended use"

3.4.1 Placing the product on a bench top

To place the product on a bench top
1. Place the product on a stable, flat and level surface. Ensure that the surface can
support the weight of the product. For information on the weight, see the data
sheet.
2. CAUTION! Foldable feet can collapse. See
Always fold the feet completely in or out. With folded-out feet, do not place any-
thing on top or underneath the product.
3. WARNING! A stack of products can fall over and cause injury. Never stack more
than three products on top of each other. Instead, mount them in a rack.
Stack as follows:
●
●
●
User Manual 1179.3073.02 ─ 02
on page 6
on page 5
If the products have foldable feet, fold them in completely.
It is best if all products have the same dimensions (width and length). If the
products have different dimensions, stack according to size and place the
smallest product on top.
Do not exceed the permissible total load placed on the product at the bottom of
the stack:
– 50 kg when stacking products of identical dimensions (left figure).
– 25 kg when stacking smaller products on top (middle figure).
Preparing for use
Setting up the product
"Setting up the product" on page 6.
11