Mounting The Product In A Rack - R&S QAT100 User Manual

®
R&S QAT100
Left
Middle = Stacked correctly, different dimensions
Right = Stacked incorrectly, too many products
4. NOTICE! Overheating can damage the product.
Prevent overheating as follows:
●
●

3.4.2 Mounting the product in a rack

To prepare the rack
1. Observe the requirements and instructions in
2. NOTICE! Insufficient airflow can cause overheating and damage the product.
Design and implement an efficient ventilation concept for the rack.
To mount the product in a rack
1. Use an adapter kit to prepare the product for rack mounting.
a) Order the rack adapter kit designed for the product. For the order number, see
b) Mount the adapter kit. Follow the assembly instructions provided with the
2. Lift the product to shelf height.
3. Grab the handles and push the product onto the shelf until the rack brackets fit
closely to the rack.
4. Tighten all screws at the rack brackets with a tightening torque of 1.2 Nm to secure
the product at the rack.
To unmount the product from a rack
1. Loosen the screws at the rack brackets.
2. Bring the lifting equipment to shelf height.
3. Remove the product from the rack.
4. If placing the product on a bench top again, unmount the adapter kit from the prod-
uct. Follow the instructions provided with the adapter kit.
User Manual 1179.3073.02 ─ 02
= Stacked correctly, same dimensions
Keep a minimum distance of 10 cm between the fan openings of the product
and any object in the vicinity.
Do not place the product next to heat-generating equipment such as radiators
or other products.
data sheet.
adapter kit.
Preparing for use
Setting up the product
"Setting up the product" on page 6.
12