Preparing For Use; Lifting And Carrying; Unpacking And Checking; Choosing The Operating Site - R&S QAT100 User Manual

®
R&S QAT100

3 Preparing for use

Here, you can find basic information about setting up the product for the first time.

3.1 Lifting and carrying

You can carry the R&S QAT by its handles on the side or on the top. Do not apply
excessive external force to the handles.
See

3.2 Unpacking and checking

1. Unpack the product carefully.
2. Retain the original packing material. Use it when transporting or shipping the prod-
uct later.
3. Using the delivery notes, check the equipment for completeness.
4. Check the equipment for damage.
If the delivery is incomplete or equipment is damaged, contact Rohde & Schwarz.

3.3 Choosing the operating site

Specific operating conditions ensure proper operation and avoid damage to the prod-
uct and connected devices. For information on environmental conditions such as ambi-
ent temperature and humidity, see the data sheet.
See also
Electromagnetic compatibility classes
The electromagnetic compatibility (EMC) class indicates where you can operate the
product. The EMC class of the product is given in the data sheet under "General data".
●
Class B equipment is suitable for use in:
–
–
●
Class A equipment is intended for use in industrial environments. It can cause
radio disturbances in residential environments due to possible conducted and radi-
ated disturbances. It is therefore not suitable for class B environments.
User Manual 1179.3073.02 ─ 02
"Lifting and carrying the product"
"Choosing the operating site"
Residential environments
Environments that are directly connected to a low-voltage supply network that
supplies residential buildings
Choosing the operating site
on page 5.
on page 6.
Preparing for use
10