Table of Contents
Advertisement
1. Set the function
maximum temperature.
2. Let the oven operate for 1 hour.
3. Set the function
maximum temperature. The
maximum temperature for this
function is 210 °C.
4. Let the oven operate for 15 minutes.
5. Set the function
Steam
temperature.
6. HOB - DAILY USE
WARNING!
Refer to Safety chapters.
6.1 Ignition of the hob burner
Always light the burner
before you put on the
cookware.
WARNING!
Be very careful when you
use open fire in the kitchen
environment. The
manufacturer declines any
responsibility in case of the
flame misuse.
1. Turn the knob for the hob
counterclockwise to the maximum
gas flow position
down to light the burner.
2. Keep the knob for the hob pushed for
equal or less than 10 seconds to let
the thermocouple warm up. If not, the
gas supply is interrupted.
3. Adjust the flame after it is regular.
WARNING!
Do not keep the knob
pushed for more than 15
seconds. If the burner does
not light after 15 seconds,
release the knob, turn it into
the off position and try to
light the burner again after
minimum 1 minute.
. Set the
. Set the
, press: Plus
. Set the maximum
and push it
6. Let the oven operate for 15 minutes.
7. Turn off the oven and let it cool
down.
Accessories can become hotter than
usual. The oven can emit an odour and
smoke. Make sure that the airflow in the
room is sufficient.
If after some tries the burner
does not light, check if the
crown and its cap are in the
correct position.
In the absence of electricity
you can ignite the burner
without an electrical device.
In this case approach the
burner with a flame, push
the relevant knob down and
turn it to maximum position.
Keep the knob pushed for
equal or less than 10
seconds to let the
thermocouple warm up.
If the burner accidentally
goes out, turn the knob to
the off position and try to
light the burner again after
minimum 1 minute.
The spark generator can
start automatically when you
switch on the mains, after
installation or a power cut. It
is normal.
ENGLISH
15
Advertisement
Table of Contents
