Troubleshooting - Electrolux RKK660201W User Manual

The drawer below the oven can be
removed for cleaning.
1. Pull the drawer out until it stops.
2. Slowly lift the drawer.
3. Pull the drawer out fully.
To install the drawer, do the above steps
in the opposite sequence.

14. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
14.1 What to do if...
Problem
There is no spark when
you try to activate the
spark generator.
The flame extinguishes im‐
mediately after ignition.
The flame ring is uneven.
The burners do not work.
13.7 Replacing the lamp
1. Turn off the oven. Wait until the oven
is cold.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the
cavity.
The back lamp
1. Turn the lamp glass cover to remove
it.
2. Clean the glass cover.
3. Replace the lamp with a suitable
300 °C heat-resistant lamp.
4. Install the glass cover.
Possible cause
The hob is not connected
to an electrical supply or it
is connected incorrectly.
The fuse is blown.
Burner cap and crown are
placed incorrectly.
Thermocouple is not heat‐
ed up sufficiently.
Burner crown is blocked
with food residues.
There is no gas supply.
WARNING!
Risk of electric shock.
The lamp can be hot.
Remedy
Check if the hob is correct‐
ly connected to the electri‐
cal supply. Refer to the
connection diagram.
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
Place the burner cap and
crown correctly.
After lightning the flame,
keep the spark generator
activated for equal or less
than 10 seconds.
Make sure that the injector
is not blocked and the
burner crown is clean.
Check the gas connection.
ENGLISH 33