Air Temperature Control Module - Dräger Incubator 8000 NC Operating Instructions Manual

What's What

Air Temperature Control Module

2.1 Key to switch on air temperature control (only with
skin temperature control option).
2.2 Unlocking key,extends range for set
temperatures
Yellow LED >37 °C,
2.3
is lit when a higher range of values has been set.
2.4 Green LED ,
indicates warming-up phase.
2.5 Green LED Control,
stays lit while air temperature control is on (only
when skin temperature control module is installed).
2.6 Display for actual (measured) value of air
temperature.
2.7 Display for set value of air temperature;
left key: decreases set value
right key: increases set value
Red LED ±1.5 °C
2.8
flashes/is lit while the measured value of the air
temperature is deviating from the set value by more
than 1.5 °C.
2.9 Red LED Sensor
flashes when air temperature sensor is defective.
2.10 Red LED
flashes in case of fan failure.
2.11 Red LED for overtemperature
Lights up when air temperature is or was higher
than 38 °C (40 °C during operation in extended
range) and after an inop-alarm.
2.12 Key to reset overtemperature alarm.
18
Air Temperature Control
°C LUFT/AIR
2.6
°C
2.7 °C
2.8
±1,5 °C
Reset
2.9
Sensor
2.10 2.11 2.12
Module
2.5
Control
2.4
2.3
>37 °C
2.2
>37 °C
2.1
Control