SmartNode 200 User Manual
Introduction
This section provides information on the cables used to connect the SmartNode device to the existing network
infrastructure and to third party products.
Ethernet
Ethernet devices (10/100Base-T) are connected to the SmartNode over a cable with an RJ-45 plug. The Ether-
net port on the SmartNode device is Auto-MDX. Use any straight or crossover cable to a host, switch, PC or
other device.
CAUTION
Figure 11. Typical Ethernet straight-through cable diagram for 10/100Base-T
Introduction
The interconnecting cable shall be acceptable for external use
an shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceability.
C • Cabling
45