Connecting Cables; Connecting Analog Interface Cable Or Cables; Analog Fxs Connection - Patton SmartNode SN200 User Manual

SmartNode 200 User Manual

Connecting cables

WARNING
WARNING
Connect the cables in the following order:
1. Connect the RJ-11 FXS analog port cable or cables (see
2. If your device is equipped with an FXO port, connect the RJ-11 FXO analog port cable
3. Connect the 10/100Base-T Ethernet LAN cable (see

Connecting analog interface cable or cables

SN200 models are available with FXS or with 1 FXS and 1 FXO ports.
Check the product webpage under the ordering tab for a detailed list of available models.
The FXS interfaces are connected to analog devices via cables (see
(see section "Analog FXS"
POTS line to the FXO ports of the SmartNode (see
Installing the SmartNode device
Do not work on the system or connect or disconnect
cables during periods of lightning activity.
The interconnecting cables shall be acceptable for external
use and shall be rated for the proper application with
respect to voltage, current, anticipated temperature, flam-
mability, and mechanical serviceability.
on page 46), while the same type of cable and pinout is being used to connect a
Figure 7. Analog FXS connection
page 27)
page 28)
figure 7) terminated with RJ-11 connectors
figure 8 on page 28).
4 • SmartNode Installation
27