Table of Contents
Advertisement
SmartNode 200 User Manual
Figure 10. Connecting SmartNode device and PC to a LAN with DHCP server.
You can check the connection to the SmartNode by executing the ping command from the PC command win-
dow as follows:
ping 192.168.200.10
Configure the Desired IP Address
Factory-default IP Settings
The factory default configuration for the Ethernet interface is listed in
(WAN) has a DHCP client running and a fixed IP address.
Table 5. Factory Default IP Address and Network Mask Configuration
WAN Interface Ethernet 0 (ETH 0/0)
Fixed IP
DHCP client
If these addresses match with those of your network, go to section
page 33. Otherwise, refer to the following sections to change the addresses and network masks.
Login
To access the SmartNode, start the Telnet application. Type either the default IP address into the address field
of the Telnet application:
192.168.200.10
Or use the
SN Discovery Tool
Connecting the SN200 to a laptop PC
192.168.200.10
DHCP
to find out the IP address previously assigned by the DHCP server.
table
5. The interface bound to ETH 0/0
IP Address
255.255.255.0
DHCP
"Loading the Configuration (optional)"
5 • Initial Configuration
Network Mask
on
32
Hide quick links:
Advertisement
Table of Contents
