Additional Information - Patton SmartNode SN200 User Manual

SmartNode 200 User Manual
Optionally, you may execute the Wizard that matches your application online, and import the generated .cfg
config into the SmartNode device.
In addition to that the Knowledgebase
If your application is unique and not covered by any of Patton's configura-
Note
tion templates, you can manually configure the SmartNode instead of load-
ing a configuration file template. In that case, refer to the Trinity Command
Line Reference Guide for information on configuring the SmartNode device.
In this example we assume the TFTP server on the host with the IP address 172.16.1.11 and the configuration
named SN.cfg in the root directory of the TFTP server.
172.16.1.99(if-ip)[WAN]#copy tftp://172.16.1.11/sn.cfg startup-config
172.16.1.99(if-ip)[WAN]#
After the SmartNode device has been rebooted the new startup configuration will be activated.
172.16.1.99(if-ip)[WAN]#reload
Press 'yes' to restart, 'no' to cancel :yes
The system is going down NOW

Additional Information

For detailed information about configuring and operating guidance, set-up procedures, and troubleshooting,
refer to the Trinity Command Line Reference Guide available online at www.patton.com/manuals.

Additional Information

provides configuration file templates that may fit your application.
5 • Initial Configuration
34