Table of Contents
Advertisement
DIGITAL-LOGIC AG
13.2 Error on boot time
A. If the display works:
1.
Check if you have a bootable floppy or harddisk.
2.
Check the CMOS parameter with the setup tools.
3.
Reset the CMOS RAM with the reset jumper J27 on the board. Close Jumper J27 for 5 seconds until
the power-on procedure. Remove the jumper and the system will start with BIOS-defaults.
4.
Re-enter the correct values with Setup.
B. If no display on the screen is available:
1.
Check the power circuitry.
2.
Check the polarities of the cables.
3.
Measure the voltage of the power supply under load and offload.
4.
Measure the current between the supply and the MICROSPACE PC.
5.
Connect a floppy: does the bezel led light blink?
6.
Does the harddisk spindle motor start?
7.
Reset the CMOS-RAM: see A.3.
C. If the error appears again
1.
Contact your nearest Digital-Logic dealer for Technical Support.
2.
Or contact our Technical Support by Fax ++41 32 681 53 31
DIGITAL-LOGIC AG, Switzerland
132
PCCP5 Manual V2.3
Advertisement
Table of Contents
