Ethernet Hardware Configuration - DIGITAL-LOGIC MICROSPACE PCC-P5 Technical User's Manual

DIGITAL-LOGIC AG

9.2 Ethernet hardware configuration

The Ethernet controller is hardware selectable with preprogrammed values from the EEPROM. This is the
normal way to start with all operating systems and NOS.
A. Select the configuration
Selected using the IOS0 - IOS2 jumper.
Refer to the table in the previous chapter.
! RESTART THE PC SYSTEM TO INITIALIZE THE NEW CONFIGURATION !
B. Generate the corresponding NET.CFG file
The NET.CFG file can be altered or created using a normal ASCII editor or with the tools from Digital-Logic.
This step must be taken at the beginning or after selecting a new configuration.
BCONF
C. Starting the Network driver on the workstation: for NW3.11
The following drivers and files are available on the tool disk.
Start the following files in this order (include in the Autoexec.bat file)
Now you can login with your password.
D. Starting the Network driver on the workstation: for Novell Lite
On the tool disk the following drivers and files are available.
Start the following files in this order (include in the Autoexec.bat file)
Now you can login with your password.
Create the correct NET.CFG files
LSL
SMC90000
IPXODI
NETX
LSL
SMC90000
IPXODI
CLIENT
low level driver
SMC Driver for Novell V3.11
IPX- ODI Driver
Novell Network Shell
low level driver
SMC Driver for Novell V3.11
IPX-ODI Driver
Lite V1.1 Workstation Shell
115
PCCP5 Manual V2.3