Table of Contents
Advertisement
DIGITAL-LOGIC AG
7.3 The Harddisk Cable 44 pins
IDT Terminal for Dual Row (2.00 mm grid) and 1.00 mm flat cable. 44 pins = 40 pins signal and 4 pins
power.
1 2
44 x
2mm
pin spacing
43 44
Max. length for the IDE cable is 30 cm.
ATTENTION:
Check the pin 1 marker of the cable and the connector before you power-on. See the technical manual of the
drives used, because a wrong cable will immediately destroy the drive and/or the MICROSPACE PCC-P5
board. There is no warranty in this case. Without the technical manual you cannot connect this type of drive.
The 44 pins IDE connector on the drives are normally composed of the 44 pins and 2 open pins and 4 test
pins, total: 50 pins. Leave the 4 test pins unconnected .
c d
a b
1 3
Testpin
open pin
Pin spacing = 1mm
44pin IDE Interface with integrated power lines
111
PCCP5 Manual V2.3
1 2
43 44
43
Advertisement
Table of Contents
