FLATPANEL MANUAL V4.6 REFACE This manual is for integrators and programmers of systems based on the MICROSPACE card family. It contains information on hardware requirements, interconnections, and details of how to program the sys- tem. The specifications given in this manual were correct at the time of printing; advances mean that some may have changed in the meantime.
1.4.1 For a new LCD type, not available now: If the LCD BIOS for your LCD is not available, DIGITAL-LOGIC will adapt the LCD and provide you with one working cable. To initialise this, we need the following points from you: 1.
These controllers allow a maximum of flexibility to interface with the most available flatpanels on the mar- ket. In this manual, we describe the cable connection using different flatpanels with MICROSPACE com- puters. The signals on the flatpanel interface are the following:...
DIGITAL-LOGIC AG FLATPANEL MANUAL V4.6 Attachment tips This section describes special issues, if you are interfacing an LCD to our products (e.g.MSE-P5AT): This product has no integrated power switches for the LCD. That means, if you need a controlled power...
LCD types. Disconnect the flat panel from the cable. Adjust the VEE voltage and polarity on the MICROSPACE product or external voltage source (if needed). Measure the VEE voltage with a multimeter, to be sure that the voltage is correct (if needed).
DIGITAL-LOGIC AG FLATPANEL MANUAL V4.6 4.6 LCD-Connector on MSM-P5 V2.0/ V3.0/ V4.0 Board Board Version MSM-P5 V2.0/ V3.0 VGA-Controller 65554 (<V4.0) Connector(s) 69000 (=>V4.0) J32(<V3.0) / J45(V4.0) Notes V3.0 revision does only support 24bit LCD interface (J32 not available) V4.0 supports up to 36bit LCD interface (bits P26 to P35 on J45) Controller signal Connector J5 pin no.
Page 17
DIGITAL-LOGIC AG FLATPANEL MANUAL V4.6 Controller signal Connector J32( pin no. Voltage Level 17 of 55...
DIGITAL-LOGIC AG FLATPANEL MANUAL V4.6 4.13 LCD-Connector on MSEP5-IPCI V1.1 Board MSEP5-IPCI Board Version V1.1 VGA-Controller Connector(s) 65548 PCI J8,J7 Notes Controller signal Connector J8 pin no. Voltage Level M / DE EVDD EBKL N.C. EVEE N.C. N.C. N.C. N.C.
Page 27
DIGITAL-LOGIC AG FLATPANEL MANUAL V4.6 Controller signal Connector J7 pin no. Voltage Level VGAR ANALOG RED VGAG ANALOG GREEN VGAB ANALOG BLUE VGAR ANALOG RED 27 of 55...
DIGITAL-LOGIC AG FLATPANEL MANUAL V4.6 4.14 LCD-Connector on MSEP5-AT V2.1 Board Board Version MSEP5-AT V2.1 VGA-Controller 65554 Connector(s) Notes Controller signal Connector J56 pin Nr. Voltage level M / DE EBKL VCCPAN 3,3V/5V (J8) EVEE EVDD GPIO2 +12V +12V if supplied...
DIGITAL-LOGIC AG FLATPANEL MANUAL V4.6 4.15 LCD-Connector on MSEP5-AT V1.0 Board Board Version MSEP5-AT V1.0 VGA-Controller 65554 Connector(s) Notes Controller signal Connector J56 pin Nr. Voltage level M / DE EBKL VCCPAN 3,3V/5V (J8) EVEE EVDD VPCLK +12V +12V if supplied...
DIGITAL-LOGIC AG FLATPANEL MANUAL V4.6 4.16 LCD-Connector on PCC-P5 V2.1(A) Board Board Version PCC-P5 V2.1(A) VGA-Controller 65554 Connector(s) Notes Controller signal Connector J5 pin no. Voltage Level M / DE VBACKSAVE Switched 12V 1A if supplied externally VCCPAN 3,3V/5V (J54)
DIGITAL-LOGIC AG FLATPANEL MANUAL V4.6 4.20 LCD-Connector on MSWS3 V3.1 Board Board Version MSWS3 V3.1 VGA-Controller 65554 Connector(s) Notes Controller signal Connector J10 pin no. Voltage Level M / DE EBKL / VBACKSAVE Switched 12V / 1A if supplied externally...
DIGITAL-LOGIC AG FLATPANEL MANUAL V4.6 4.21 LCD-Connector on MSM486SEV, V1.1 Board Board Version MSM486SEV V1.1 VGA-Controller 65548 Connector(s) J17 L/ J17 M Notes Controller signal Connector J17 L Voltage Level pin no. M / DE EVDD SCLK EBKL EVEE 3.3V or 5V...
DIGITAL-LOGIC AG FLATPANEL MANUAL V4.6 4.27 LCD-Connector on MSM586SEV V2.x Board Board Version MSM586SEV since V2.1 VGA-Controller 69000 Connector(s) J7L / J7M Notes Controller signal Connector J7 L Voltage Level pin no. M / DE 3.3/5V / 1A switched selected by J51...
DIGITAL-LOGIC AG FLATPANEL MANUAL V4.6 4.29 LCD-Connector on SM486PCX- DK V1.x Board SM486PCX- DK Board Version V1.x VGA-Controller 65548/50 Connector(s) J17L / J17M Notes Controller signal Connector J17 L Voltage Level pin no. M / DE EVDD SCLK EEBKL EVEE LCD Vcc 5V/3.3V...
Page 46
DIGITAL-LOGIC AG FLATPANEL MANUAL V4.6 4.30 LCD-Connector on SM486PC- DK, V2.x Board SM486PC- DK Board Version since V2.1 VGA-Controller 65545/48 Connector(s) J17L / J17M Notes Controller signal Connector J17 L Voltage Level pin no. M / DE VEESAVE 5V / 1A switched...
DIGITAL-LOGIC AG FLATPANEL MANUAL V4.6 5 ELAN400 ¼ VGA DIRECT CONNECTED DISPLAY The ELAN400 does also include an internal LCD-controller. This controller does supports CGA- and ¼- VGA-Displays. The picture has a CGA (320x200) resolution and will repeat the last 40 lines if the whole screen is filled.
DIGITAL-LOGIC AG FLATPANEL MANUAL V4.6 ELAN400 CGA ISPLAY ADAPTIONS FOR THE CONTROLLER 6.1 4bit displays CGA-init table for LCD PC067AYE (160x128 CGA display) Display Signal Board Signal Board Signal Texture MSM486SL SM486PC- Speaker Anode Speaker Cathode [LVDD] (+5V) Power (3.3V) [LVDD] (+5V) Enable 3.3V to the entire...
Page 53
DIGITAL-LOGIC AG FLATPANEL MANUAL V4.6 CGA-init table for LCD SP14Q002 (320x240 1/4-VGA display) Display Signal Board Signal Board Signal Texture MSM486SL SM486PC- Serial row data [LCDD0] Serial row data [LCDD2] Serial row data [LCDD3] DISP OFF VDD [LVDD] Control display off...
DIGITAL-LOGIC AG FLATPANEL MANUAL V4.6 6.2 8bit displays CGA-init table for LCD KCS3224 (320x200 1/4-VGA display) No table available CGA-init table for LM6083SGE (640x200 CGA display) No table available 54 of 55...
Need help?
Do you have a question about the MICROSPACE and is the answer not in the manual?
Questions and answers