Ethernet Lan; Ethernet Io-Address And Irq Selection - DIGITAL-LOGIC MICROSPACE PCC-P5 Technical User's Manual

DIGITAL-LOGIC AG
9 E
THERNET

9.1 Ethernet IO-Address and IRQ selection

The Ethernet interface is configured with the values stored in an EEPROM. The default values are:
Jumper J41
Configuration IOS0
0 closed
1 open
2 closed
3 open
4 closed
5 open
6 closed
7 open
On the board, the default configuration and the selected configuration are labeled. The label also contains
the unique node address:
Label example:
NODE:
0
1
* 2
3
4
5
6
The asterisk * in front of the configuration 2 line marks the selected configuration. You can change the hard-
ware configuration by modifying the jumper IOS0 - IOS2.
The software downloaded configuration ise recommended only for custom cases, where the values must be
altered, without soldering the jumpers onboard. The downloaded configuration works only with Novell V3.11
and Novell Lite and all other ODI driver NOS.
For OS/2, NT and UNIX applications always use the hardware configuration, because the drivers are
adapted only for hardware configuration schemes.
LAN
J42 J43
IOS1 IOS2
closed closed
closed closed
open closed
open closed
closed open
closed open
open open
open open
aabbccddeeff
340 i5 8
340 i10 16
320 i11 16
300 i5 8
340 i5 8
340 i10 16
320 i11 16
Base
address
340
340
320
300
340
340
320
Software downloadable configuration
TYPE: B
AUI
AUI
AUI
AUI
10BASE-T
10BASE-T
10BASE-T
114
PCCP5 Manual V2.3
IRQ BUS INTERFACE
5 8 AUI/COAX
10 16 AUI/COAX
11 16 AUI/COAX
2/9 8 AUI/COAX
5 8 10BASE-T
10 16 10BASE-T
11 16 10BASE-T