LIGHT OBJECT LO-E5 Manual page 16

Table of Contents

Advertisement

Max Acceleration: Acceleration when axis increases or decreases
movement. Too big of a setting may lead to motor losing steps or
dither; too small of a setting may cause slow acceleration and then
slow processing speed for whole image. For axis with big resistance,
such as Y axis corresponding with beams, typical setting should be
within in 800~3000mm/s2 ; For axis with small resistance, such as X
axis corresponding with carts, the typical setting should be within
10000 ~20000mm/s2;
Max Speed: The motor drive ability and resistance of moving axis
decides the max speed that motion axis can reach. During engraving
process, engraving speed can not surpass the max speed value
corresponding with the engraving axis. During cutting process, the
resultant speed can not surpass the min speed of X and Y axis. If
speed setting is too large, controller will automatically limit the speed
below max speed for safety.
IO Function Switch
Water Protect: The water protection ports of AWC708 control panel
are Laser1.Protect and Laser2.Protect. When Water Protect is
selected, system will apply real-time monitoring water protection
signal of the 2 ports. If any of the port signals gets too high of a level,
processing job will be suspended, and laser will be closed. Meanwhile
"Water protect" will be shown on LCD Panel.
Open Protect: The open protect port of AWC708 control panel is IN1.
When [Open protect] is selected, system will apply real-time
monitoring protection signal of the port. If the port signal comes to be
too low of a level, processing job will be suspended; when the port
signal comes to a higher level, suspended job will resume.
Foot Switch:The foot switch port of AWC708 control panel is
IN2. When Foot Switch is selected, system will apply real-time
monitoring protection signal of the port. If the port signal
changes from a high level to a low level, the processing job
will be suspended or suspended job will resume.
13

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the LO-E5 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents