Table of Contents
Advertisement
INSTALLING THE BLADE/BLADE HOLDER TO FAN MOTOR
Step 8. To reach the blade holder mounting
holes in the fan motor the dummy switch
housing must be removed.
Take out the two 5-32 X
9
/
32
ing the dummy switch housing and remove.
Set the two (2) screws aside for the mo-
ment, they will be used in Step 12 to install
the switch housing after the blades are in-
stalled.
The dummy switch housing is used only when
shipping the fan.
Note: Save these two screws–they
will be used in Step 12.
BLADE SCREW
(4 PER BLADE)
BLADE HOLDER
(2 PER BLADE)
Step 9. Attach the blades to the blade
holders by first pressing the blade badge
into the blade, then installing the blade
holder using the four blade screws and
flat washers provided for each blade.
Using the screwdriver, tighten securely
by hand only.
Repeat for each blade assembly.
BLADE SCREW
(4 PER BLADE)
6
PREPARATION
" screws secur-
BLADE & BLADE HOLDER HARDWARE
SCREW
BLADE INSTALLATION
BLADE
BADGE
DUMMY
SWITCH
HOUSING
BLADE
HOLDER
BLADE
HOLDER
BLADE
Advertisement
Table of Contents
