Table of Contents
Advertisement
Step 17. Carefully slide the glass into the light kit as
shown.
GLASS
Step 18. Lift the light fixture to the switch housing, run-
ning the cap screws through the key holes.
CAUTION! Make sure you feed extra wire from
the light fixture through the center hole of
the switch housing to avoid pinched wires.
Turn the light fixture left (counter-clockwise) to engage
the screws in the key holes.
TIGHTEN SCREWS, INSTALL BULBS & PLACE GLASS
Step 19. Carefully push the glass aside
to access the cap screws. Ensure that
the screws are properly engaged in the
keyholes and tighten firmly by hand.
Step 20. Install the two 100 Watt bulbs.
Step 21. Carefully slide the glass down
into place.
CAUTION! TO REDUCE THE RISK
OF FIRE USE MAX TWO 100W A15
INCANDESCENT LIGHT BULBS.
You may now proceed to
the fan control system for
your fan.
B
RESCIA
LIGHT FIXTURE GLASS INSTALLATION
ATTACH LIGHT KIT TO FAN
CAP
SCREWS
100W
A15
BULBS
FAN CONTROLS
R
For Inteli•Touch (wall control) operation,
please see the instructions on Page 11.
(G
E
ALLERY
DITION
LIGHT KIT
For Comfort•Touch models (remote control),
please see the directions on Page 15.
)
GLASS
GLASS
R
9
Advertisement
Table of Contents
